CCNA2 v6.0 Chapter 7 Exam Full 2017 100%

CCNA2 v6.0 Chapter 7 Exam Full 2017 100% 1. Question In which configuration would an outbound ACL placement be preferred over an inbound ACL placement?  when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interface  when a router has more than one […]
Continue reading…

 

CCNA2 v6.0 Chapter 6 Exam Full 2017 100%

CCNA2 v6.0 Chapter 6 Exam Full 2017 100% 1. Question What are three primary benefits of using VLANs? (Choose three.)  security  a reduction in the number of trunk links  cost reduction  end user satisfaction  improved IT staff efficiency  no required configuration 2. Question Which type of VLAN is used to designate which traffic is untagged […]
Continue reading…

 

CCNA2 v6.0 Chapter 4 Exam Full 2017 100%

CCNA2 v6.0 Chapter 4 Exam Full 2017 100% 1. Question A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.)  lower bandwidth requirements […]
Continue reading…

 

CCNA2 v6.0 Chapter 3 Exam Full 2017 100%

CCNA2 v6.0 Chapter 3 Exam Full 2017 100% 1. Question Which dynamic routing protocol was developed to interconnect different Internet service providers?  BGP  EIGRP  OSPF  RIP 2. Question Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks?  OSPF  RIP  EIGRP  IS-IS 3. Question What two tasks […]
Continue reading…

 

CCNA2 v6.0 Chapter 2 Exam Full 2017 100%

CCNA2 v6.0 Chapter 2 Exam Full 2017 100% 1. Question What are two advantages of static routing over dynamic routing? (Choose two.)  Static routing is more secure because it does not advertise over the network.  Static routing scales well with expanding networks.  Static routing requires very little knowledge of the network for correct implementation.  Static […]
Continue reading…

 

CCNA2 v6.0 Chapter 1 Exam Full 2017 100%

1. Question A network administrator enters the command copy running-config startup-config. Which type of memory will the startup configuration be placed into?  flash  RAM  NVRAM  ROM 2. Question Which packet-forwarding method does a router use to make switching decisions when it is using a forwarding information base and an adjacency table?  fast switching  Cisco Express […]
Continue reading…

 

CCENT (ICND1) Certification Exam

CCENT (ICND1) Certification Exam  A network technician is configuring port security on a LAN switch interface. The security policy requires host MAC addresses to be learned dynamically, stored in the address table, and saved to the switch running configuration. Which command does the technician need to add to the following configuration to implement this policy? […]
Continue reading…

 

CCNA2 v6.0 Practice Final

CCNA2 v6.0 Practice Final The buffers for packet processing and the running configuration file are temporarily stored in which type of router memory? flash NVRAM RAM ROM What is the minimum configuration for a router interface that is participating in IPv6 routing? to have only a link-local IPv6 address to have both an IPv4 and […]
Continue reading…

 

CCNA2 v6.0 Pretest Exam

CCNA2 v6.0 Pretest Exam Which two components are configured via software in order for a PC to participate in a network environment? (Choose two.) MAC address IP address kernel shell subnet mask What is the correct order for PDU encapsulation? To revert to a previous configuration, an administrator issues the command copy tftp startup-config on […]
Continue reading…